The forum is now archived and available for reading only. To find older posts, you can use a search engine.
If you need assistance, you can contact our Support or use Steam discussions, Discord or Reddit. Thank you.

Post Reply 
Defining variables in GLEAMviz
04-04-2020, 02:44 PM
Post: #1
Lightbulb Defining variables in GLEAMviz
Good afternoon

I am using GLEAMviz to make a covid-19 simulation.

I would like to ask all, if possible, if you could help me on the parameters to use in the simulation of covid-19 in the sofware, either it's a SIR or SEIR model.

I don't quite understand the units used for the value of beta (the numerical term used from the susceptibles to the infected) or gamma (from Infected to recovered).

Could you help me on which values to use in the covid-19 case so I can run a simulation and understand the units in future simulations?

Please answer as soon as possible. This is quite important.

Kind regards

Find all posts by this user
Quote this message in a reply
Post Reply 

Forum Jump:

User(s) browsing this thread: 1 Guest(s)